Engineer Talks

ENGINEER TALKS Ep.25: Marine Pipe Thread Chart: BSP, NPT & NPSM Identification and Sealing Interfaces

Identify marine pipe threads by the numbers: BSP vs NPT flank angles, taper versus parallel, common size references and where each joint actually seals.

ENGINEER TALKS Ep.24: Why 316 Stainless Steel Rusts: Tea Staining, Pitting & Contamination Checks

Diagnose brown marks on 316 stainless steel: tea staining, free-iron contamination, pitting and crevice corrosion, and how to record, clean, inspect and specify.

ENGINEER TALKS Ep.23: Anchor Swivels & Shackles: Side Loads, Articulation and Connection Geometry

An engineering guide to anchor swivels and shackles. See how axial rotation, articulation and shank orientation differ, where off-axis loads travel, and the interface checks OEM buyers need.

ENGINEER TALKS Ep.22: Anchor Chain Size Chart: Link Dimensions, Standards & Windlass Compatibility

Anchor chain size chart guide for buyers: link pitch, inside and outside width, DIN 766 vs ISO 4565, and matching a 10 mm chain to the windlass gypsy.

ENGINEER TALKS Ep.21: Marine Hinge Sizing for Heavy Hatches and Doors: Loads, Motion & Mounting

Compare published hinge load, torque, and hatch layout references. Learn how to screen marine hinges by panel motion, mounting support, and rating scope.

ENGINEER TALKS Ep.20: Flush Mount Rod Holder Size Chart—Angles, Clearances, and Drainage

Compare 0°, 15°, and 30° flush mount rod holders. Check usable bore, installation clearance, mounting details, and drainage before ordering.

ENGINEER TALKS Ep.19: Bimini Top Hardware Sizing—Tube OD, Eye Ends, and Fitting Compatibility

Compare 7/8", 1", and 1-1/4" Bimini tubing sizes. Check eye ends, jaw slides, hinge interfaces, and fitting compatibility before ordering.

ENGINEER TALKS Ep.18: Marine Hatch Hinge, Latch & Gasket Systems: Axis, Clamp Spread & Seal Checks

An engineer-led guide to marine hatch closure systems: hinge axis alignment, latch clamp distribution, seal compression stack-up, and commissioning checks.

<1 2 3 4 5 >